Primary shaft
Posted: Wed Aug 10, 2016 1:13 pm
Hi Guys
My new primary shaft main bearing has just arrived, however looking at the shaft, there is a bevel washer which goes between the main bearing /Bearing holder, up against a shoulder on the primary shaft against the small needle roller bearing which the starter assembly turns on. My photo I took of the assembly is not good enough (must take more care!) to show which side the bevel side of the washer goes up against- The bearing or the shoulder. the witness marks on either side of the washer are inconclusive, as is the manual diagram.
I would really appreciate it if someone could point me in the right direction on this one please.
Best Regards
Martin
My new primary shaft main bearing has just arrived, however looking at the shaft, there is a bevel washer which goes between the main bearing /Bearing holder, up against a shoulder on the primary shaft against the small needle roller bearing which the starter assembly turns on. My photo I took of the assembly is not good enough (must take more care!) to show which side the bevel side of the washer goes up against- The bearing or the shoulder. the witness marks on either side of the washer are inconclusive, as is the manual diagram.
I would really appreciate it if someone could point me in the right direction on this one please.
Best Regards
Martin