Looking at the rods I understand the # and letters. I dont understand the difference between an S1 or S2 rod.
I have one rod marked S1 and the rest S2.
Con Rods
-
CopperCollar
- ICOA Member
- Posts: 442
- Joined: Mon Dec 20, 2010 3:32 pm
- Location: Albuquerque, New Mexico, USA
- Location: Albuquerque, New Mexico, USA
Con Rods
I have been studying before I assemble The Travestys engine.
Looking at the rods I understand the # and letters. I dont understand the difference between an S1 or S2 rod.
I have one rod marked S1 and the rest S2.
Looking at the rods I understand the # and letters. I dont understand the difference between an S1 or S2 rod.
I have one rod marked S1 and the rest S2.
When given the choice between being right or being kind; choose kindness. W. Dyer
-
daves79x
- ICOA Technical Director
- Posts: 4755
- Joined: Sun Oct 01, 2006 8:05 am
- Location: Knox, PA
- Location: Knox, PA
Re: Con Rods
We don't really know either, but you can trust the weight codes. From the factory they should all be the same - C in your case? The journal codes will vary, but the letter codes should match. Currently Honda says A and B match, C and D and E match, and F and G match. I've never seen any E, F or G rods. Anyway, just match your C rods with the same, since there are lots of Cs out there.
Dave
Dave
-
daves79x
- ICOA Technical Director
- Posts: 4755
- Joined: Sun Oct 01, 2006 8:05 am
- Location: Knox, PA
- Location: Knox, PA
Re: Con Rods
Check your PMs
Dave
Dave