chamfered rubber seal
Posted: Tue Jun 09, 2015 2:59 pm
Hello Gents,
Embarrassing 1st posting for advice;
I’m in the process of re-commissioning a cbx1000 (1980)
Whilst I have completed most of the heavy work (apart from the carbs) I have purchased
a rear master cyl repair kit and cant believe I have been defeated by one of the
smallest parts of the bike.
There is a chamfered rubber seal that should fit onto the piston bolt/rod.......
Is there a secrete, trick or handy tip to fitting this seal over the head without
stretching or damaging it.
Regards
Edd.
Embarrassing 1st posting for advice;
I’m in the process of re-commissioning a cbx1000 (1980)
Whilst I have completed most of the heavy work (apart from the carbs) I have purchased
a rear master cyl repair kit and cant believe I have been defeated by one of the
smallest parts of the bike.
There is a chamfered rubber seal that should fit onto the piston bolt/rod.......
Is there a secrete, trick or handy tip to fitting this seal over the head without
stretching or damaging it.
Regards
Edd.