Page 1 of 1
Timing
Posted: Mon Oct 17, 2011 1:04 am
by Motoguy@64
Have just put in Dyna Ignition. Engine runs but when I do dynamic timing F line is always at about 12 oclock instead of at 3 where the engine seam is.Moving ignition plate does not seem to have any effect. Have been timing Chevys for years, but I have no clue in this case. HELP..
Re: Timing
Posted: Mon Oct 17, 2011 4:12 am
by Jeff Bennetts
Is this a fresh rebuilt motor or a stock motor that was running fine before you installed the dyno ign ?
Re: Timing
Posted: Mon Oct 17, 2011 11:18 pm
by Motoguy@64
Was running fine until spark units croaked. It does run now, and on all 6!!,but the"book"says "set the timing". I thought, piece of cake. Not so much!!!
Re: Timing
Posted: Mon Oct 17, 2011 11:33 pm
by Jeff Bennetts
Are your springs and weights moving freely on the advancer, what year CBX and what's the number stamped on your advancer?