Page 1 of 1
1982 clutch thrust washers dimensions
Posted: Sun Dec 07, 2008 2:43 pm
by bkweis
I am looking for the dimensions for the clutch thrust washer for a 1982 cbx. I do know the inside diameter 30mm but need the outside diameter
and the thickness or if some body might have two of them I can buy. Thanks Brian Weis #2516
Posted: Thu Dec 11, 2008 9:28 pm
by SteveG
Hi Brian,
Don't know if this helps, but my 82 parts list shows the part # to be 90458-MA2-000 (Thrust washer, 30mm, quantity 2).
Good Luck. Steve
Posted: Fri Dec 12, 2008 4:13 pm
by EMS
Brian, I will measure one, but I think the outside diameter is 30mm, not the inside. Consider 30mm are 1 1/4 inch!
Posted: Mon Jan 12, 2009 2:56 pm
by piit
EMS, did you measure thrust washer? Would be interesting to have thickness on it.
Posted: Mon Jan 12, 2009 3:59 pm
by EMS
Oops! Will do tonight...Sorry
Posted: Mon Jan 12, 2009 4:11 pm
by piit
No problem, it is winter here and time to wait
Posted: Fri Jan 16, 2009 4:47 pm
by piit
EMS, the spring is coming
Posted: Fri Jan 16, 2009 5:17 pm
by EMS
Outside diameter 44.9mm (44.5mm), inside diameter 30.1mm (30.0mm), thickness 0.92mm (0.86mm). I am not 100% sure whether this is the 422 or th MA2 part, however.
I have two of them loose in a box, not with a clucth assembly
Posted: Sat Jan 17, 2009 5:20 am
by piit
Thanks EMS! Thickness is the open issue for me. I do not know have the MA2 2xwashers same thickness as 422 washer. I will measure the 422 washer and compare against the figures you gave.
Posted: Sat Jan 17, 2009 10:22 am
by piit
422 washer; OD 42mm, ID 30.1, thickness 1.6mm. So, seems that EMS´s washer is from MA2.
Posted: Sat Jan 17, 2009 10:28 am
by piit
EMS; PM sent!
about clutch thrust washers
Posted: Sun Jan 18, 2009 5:11 pm
by bkweis
I would like to thanks everyone for the imformation on the clutch washers.
That is alot of good information . EMS I will see you in Columbus next weekend. thanks Brian
Posted: Wed Jan 21, 2009 9:07 am
by daves79x
Brian:
Apparently my messages to you never got there. I do have an early model clutch sleeve for you to modify. I'll bring it this weekend.
Dave
about washers
Posted: Thu Jan 22, 2009 12:21 am
by bkweis
Hi dave I did not receive any of your messages. Chuck and I will both
be there fri. evening. looking forward to this winter meet.
Thanks Brian
Posted: Mon Feb 02, 2009 4:01 pm
by piit
Seems that you gurus do not know the PL washer thickness or you are hiding it
I have tried to get this data almost two years without success. This post was not started by me, but the result seems to be same as earlier
