The International CBX Owners Association

Hi Guys!, Any ideas as to where to position my control module for my probe ignition? polite sugestions only please! , it's a standard 79 with airbox ,so somewhere unobtrusive would be great!, any advice greatfully recieved!.

many thanks guys

How about in the location vacated by the spark units? Use the spark unit bracket to model a bracket for the Probe. Go get a piece of aluminum sheet from Lowes, presto.

Thanks for the reply Nils!, Yeah, had considered this, but hoped for somewhere more easily accessible in case I fancy tinkering around with it,highly unlikely as I'd likely bugger it up!, everywhere else is rather limited space-wise?, however still open to further suggestions Nils/anyone?

The prolink's spark units mount on the rear fender. You'd have to remove the 79's tool box, though. I considered that for a while, then mounted my spark units as described in Nils' message.