The International CBX Owners Association

Posted: **Fri Apr 04, 2008 3:43 pm**

Can anyone tell me if a Stefan Jung alternator will fit a Z with Rickman crashbars.
Thanks

Posted: **Sat Apr 05, 2008 9:45 am**

Des, I am not that familiar with the fit of the Rickman bars, I just know from what I have seen on pictures that they wrap around quite a bit. If you have a Z with the small Euro alternator and the bars are very close, it is likely you may have a problem. If you have the large alternator and a little space between bars and alt housing, you should be fine.

Posted: **Sat Apr 05, 2008 10:21 am**

I have a Jung alternator fitted & could take some measurements if required Des ?

Posted: **Sun Apr 06, 2008 4:14 am**

If you could please Larry, the right side edge is most important as this is were the crash bars start to bend inwards

Posted: **Sun Apr 06, 2008 4:42 am**

Des Brown wrote:If you could please Larry, the right side edge is most important as this is were the crash bars start to bend inwards

Gotcha, The rear trailing edge. Will get it early this afternoon....

Posted: **Sun Apr 06, 2008 5:49 am**

Hope this helps Des, I have the SunDog billet cover ( now sold via TIMS) but the one Stefan uses is the original thin plate, so I measured for that.

Note: Measurements are from the center of the top rear engine bolt....Imperial measurements, sorry .

[/u]

Posted: **Sun Apr 06, 2008 6:34 am**

This is a pic from last years Minehead rally of one of UKCBXCLUB members bikes fitted with Rickman bars. I see why you are doubtful Des...

Posted: **Sun Apr 06, 2008 11:37 am**

Thanks Larry I will start measuring

Posted: **Sun Apr 06, 2008 11:55 am**

Let us know how you get on Des as I'm sure one or two others may want the same installation.....