Repro Wiring Harness Experience
-
- ICOA Web Post/Pix/Video Archive Mgt
- Posts: 2295
- Joined: Mon Dec 15, 2003 2:32 pm
- Location: Brighton, MI
- Location: Brighton, Mich
- Contact:
Re: Repro Wiring Harness Experience
Good and interesting feedback. Thanks.
Larry Zimmer
cbxlarry@sbcglobal.net
cbxlarry@sbcglobal.net
-
- ICOA Member
- Posts: 38
- Joined: Thu Jun 21, 2012 5:58 pm
- Location: La Crosse, Wisconsin, USA
- Location: La Crosse, Wisconsin, USA
Re: Repro Wiring Harness Experience
Probably nobody would notice, but I want to correct a typo I made at the start of this post. Regarding the repro harness, I wrote: "I measured [the red] wire at 1.14mm, [diameter] though probably this could be 1.50mm, which would make this wire closer to 17 gauge. "1.50mm" should have read "1.150mm". A 1.50 mm cable would be closer to 12 gauge - Ha. Not likely here.
sisxiny0da -- I agree with you; good crimps make soldering unnecessary.
sisxiny0da -- I agree with you; good crimps make soldering unnecessary.
Dick Sullivan
- NobleHops
- ICOA Member
- Posts: 3915
- Joined: Mon Jan 25, 2010 7:17 am
- Location: Tucson, Arizona, USA
- Location: Tucson, Arizona, USA
Re: Repro Wiring Harness Experience
I did just edit the post using my admin privileges, (as the author you can too, by the way), please review and see that I did it correctly, and change it if I didn’t. Use the pencil button upper right in the post.
N.
N.
Nils Menten
Tucson, Arizona, USA
'82 CBX, among others.
Tucson, Arizona, USA
'82 CBX, among others.
- herdygerdy
- Power Poster
- Posts: 266
- Joined: Fri Nov 22, 2013 9:48 pm
- Location: Sydney, Australia
- Location: Sydney, Australia
Re: Repro Wiring Harness Experience
Great post Divan, very interesting and thank you for sharing your vast knowledge on this topic. I'm sure we are all very grateful for your contribution.
-
- ICOA Member
- Posts: 38
- Joined: Thu Jun 21, 2012 5:58 pm
- Location: La Crosse, Wisconsin, USA
- Location: La Crosse, Wisconsin, USA
Re: Repro Wiring Harness Experience
Thank you, Nils. Didn't know I could edit it myself. Your edit is what it should read.
Dick Sullivan
-
- ICOA Member
- Posts: 38
- Joined: Thu Jun 21, 2012 5:58 pm
- Location: La Crosse, Wisconsin, USA
- Location: La Crosse, Wisconsin, USA
Re: Repro Wiring Harness Experience
herdygerdy -- well, not so vast; I try to share the bits I have some understanding of, since I've learned so much about this bike from this forum over many years, including some of your posts. I'd say the collective knowledge of the CBX here is indeed vast, Thanks to all who contribute. Sincerely.
Dick Sullivan