accelerator pump

DevonCbx · Post by **DevonCbx** » Sat May 12, 2007 3:27 pm

On the pump rod I am having a problem with the order of the spring, spring collar etc. I have a shop manual, but it does not seem to show the order properly. At the bottom of the rod there is a cotter pin. Do I place a washer over the cotter pin then the spring collar, followed by another washer and another cotter pin?
Thanks
Duane

EMS · Post by **EMS** » Sat May 12, 2007 4:59 pm

Duane,
I think the cotter pin and washer are on the bottom end and the spring collar is on the other side of the spring. Only one washer, one cotter pin.

alimey4u2 · Post by **alimey4u2** » Sat May 12, 2007 5:00 pm

Duane, Page 4-9 shows ( from the bottom) cotter pin, plain washer, spring, spring collar.....