The International CBX Owners Association

Hi guys, thanks for allowing me to join. Got my first 1985 CBX 750F just like my late dad and love it! However, it is clear the exhausts are still as nature intended, and also clear that the baffles need some attention / re wrap. It is outrageously loud and I need to address it. On the attached pictures, can these rivets at the end of the can be drilled out and the baffle pulled away? Any advice is much appreciated! Mike.

I’m sure if you are careful removing the rivets should be a piece of cake.

Start with a drill bit slightly smaller than the smaller rivet hole in the center. Drill it out slowly then increase the drill diameter if it’s not enough. Don’t push too much as to not hit anything but you should clear the baffle.