Here's what I've got on file, correct me if it's got some mistakes
You have to be extra careful with spark plugs, the oil pan, and the fork oil drain bolts.
As a rule, when in doubt finger-tighten and then do a 1/8 - 1/4 turn, if you set the torque wrenches wrong they will do more harm than good. I put a very tiny bit of grease on some screws and bolts for parts that I frequently remove.
-Scott
torque is critical, with oil on threads torque to the low end of scale
https://motorcyclemojo.com/2012/03/prop ... -critical/
https://www.lainefamily.com/images/Hond ... Manual.pdf
http://www.cbx.dk/Manual/r5cbx1000.pdf motor
https://www.manualslib.com/manual/10520 ... e=8#manual
- Aluminum brake banjo bolts 12-15 ft-lbs, set at 12 8/19, 13.5 9/3 2022 check banjo nuts
- rear master cylinder 8mm 7-10 ft-lbs 8.5 with 3/8 drive
- Stainless steel brake banjo bolts Torque specifications 15-17 ft. lbs
re-tighten banjo bolt nuts w pliers 9/3 2022
- Ohlins shocks 22 ft-lbs
- hex caliper brake bolts 22 ft-lbs
- rear master cyl 22 ft-lbs
- oil filter center bolt 20-24 22
- oil drain bolt 20-23 22
- oil pan bolts 6 X 25 5-8 ft-lbs set at 7 or = 84 in lbs
- rear axle nut 58-72
- drive sprocket 24-27
- spark plug 9-12 10
- fork drain bolt 6 mm bolt 5-8 ft-lbs set at 6.5
- exhaust flange nuts "Standard torque for 6mm bolt would apply: 8-10 Nm" or 5-8 ft-lbs
---
PAGE 5-0
- engine hanger hex bolts front top triangle 22-29 ft. lbs
mid-top triangle 13-18 ft. lbs
- oil cooler bracket 22-29 ft. lbs
- rear hanger bolts 65-72 ft. lbs
---
-- 1/4 " torque wrench use 1/4 in to 3/8 adapter
5 mm bolt 2.5-3.6 ft-lbs set at 3.0
6 mm bolt 5-8 ft-lbs set at 7 = 84 in-lbs
-- 1/4 or 3/8 " torque wrench
8 mm bolt 7-10 ft-lbs set at 8.5
-- 3/8 " torque wrench
10 mm bolt 17-22 ft-lbs
12 mm bolt 22-29 ft-lbs
14 mm engine bolt 65-72 ft-lbs
---
PAGE 13-0
Front Wheel Suspension
- front axle pinch bolts 13-18 ft-lbs set to 16 currently 19
--
PAGE 14-0
Rear Wheel Suspension
--
5-8 mm need 1/4 " torque wrench 20-200 inch-pounds
10-foot pound to inch pounds, the result is 120 inch-pounds
10-14 mm need 3/8 " torque wrench 10~80 Ft-Lb
--
https://www.lainefamily.com/images/Hond ... Manual.pdf
--