Does anyone know of a source for bushings that allow use of the smaller pivot shaft of the '79 swingarm with a Pro-Link arm? I'd prefer not to modify the frame.
Thanks in advance. (I've looked, but can only find older - much older - sources for these).
Pro-Link Swingarm onto '79
- desertrefugee
- ICOA Member
- Posts: 177
- Joined: Fri Mar 16, 2018 1:50 pm
- Location: Chandler, AZ
- Location: Chandler, AZ
Pro-Link Swingarm onto '79
'86 VMax, ‘83 ZN1300-6, ‘78 GL1000, '75 750K
"The older I get, the more I understand. Don't let the fear of what could happen make nothing happen." - Anonymous
"The older I get, the more I understand. Don't let the fear of what could happen make nothing happen." - Anonymous
-
- ICOA Member
- Posts: 10151
- Joined: Wed Mar 05, 2003 7:55 am
- Location: North East OH, ICOA 3904
Re: Pro-Link Swingarm onto '79
I never knew of anything readily available. I had a sleeve made to adapt a 16mm axle diameter swingarms into the 79 frame. Any decent machine shop can do this.