Lean mixtures off idle
Posted: Tue May 08, 2018 7:26 pm
Hi Guys
I have a 1981 Prolink, I overhauled the carbies, but runs lean off idle and at low speed, I did not remove the idle jets ( apparently to do this they have to be drilled and tapped to pull them out?) My main question is the carby kits I got had 6 rubber plugs, where do they go? there were none installed when I stripped down the carbs, are they for earlier models? Also where can I purchase a set of slow speed jets? Have since found a post re removing the slow jets for cleaning. My carbs had mud in the bottom of bowl, so slow jets are probably blocked.
Thanks, Steve
I have a 1981 Prolink, I overhauled the carbies, but runs lean off idle and at low speed, I did not remove the idle jets ( apparently to do this they have to be drilled and tapped to pull them out?) My main question is the carby kits I got had 6 rubber plugs, where do they go? there were none installed when I stripped down the carbs, are they for earlier models? Also where can I purchase a set of slow speed jets? Have since found a post re removing the slow jets for cleaning. My carbs had mud in the bottom of bowl, so slow jets are probably blocked.
Thanks, Steve